$17,900
Miami, Florida
Category
-
Length
-
Posted Over 1 Month
1998 23' Seaswirl Striper Walk Around. Title in hand, no loans to pay off. HERE IS THE DETAILS OF THE BOAT : The boat is a 1998 with a 2003 Evinrude 200HP Etec that had a brand new power head directly from Evinrude Installed in 2008 for $11K. The new power head is equal invent to a 2005 Evinrude Etec DI motor, per the warranty papers that came with the motor. Motor since the rebuild has under 200 hours, but theirs no way to verify that. In 2014 power tilt and trim assembly installed brand-new on the boat. The parts alone was $1095 The complete assembly was changed out instead of just doing the motor, I bought a brand-new complete assembly two months ago. The entire assembly was changed out for the tilt/trim on the motor. Boat also has trim tabs which work perfect. Remote spot light on top of T-TOP installed last year Brand new ship to shore antenna also just installed 2014 - 2 Brand new 1000CCA Batteries installed ( $400.00 ) I also just tuned it up, new plugs, water pump, fuel filters. All new fuel lines also ran from fuel tank to engine. Cost was $695.00 for the service Boat has trim tabs, 8" Color Hummingbird with side image sonar ( $2,200.00 ) Model # 997c with built in GPS. Also has 15' Taco outriggers ! Need new line, but the bases and Taco outriggrers are included, another $1,500.00 bonus! Boat is fully equipped with windless anchor, and actual head you can flush over, or, into a holding tank , salt water wash down, and fresh water wash down on transom, boarding ladder, sink, full isinglass enclosure, needs to be redone,. SS prop and more, electronics box, ship to shore radio, stereo with I-Pod hook, Remote Spot light up on top of the T-TOP , Back spreeder lights for deck , hard fiberglass T-TOP , Onboard charger system for batteries when docked and more! Boat has some small gel coat cracks just on the gel coat in a few area's. I just had a bid of $500.00 local for them to fix the area's. Their were a couple of really small dings in the gelcoat from rubbing up against a dock, I put some marine tex over them, and the local repair guy said he will sand them down and repair them with the fell coat cracks. Theirs about 4-5 small spots I did this on. He also stated the gell coat cracks weren't structural, and were only cosmetic , but may come back down the road if the boat rubs up against a dock to hard in those areas. I don't bother fixing it, as I haven't owned a boat that didn't have at least one or two spider cracks in the gell coat. Any arrangements for the repairs will be between the buyer and the repair shop if needed. Their are no blisters or anything else in the gell coat, and it shines very well for its age. I just waxed it last month. One of the light bulbs are out on the spreader lights. Also the T-TOP has two small hairline cracks in the back corners on each side where it bolts to the aluminum and fiberglass. Theirs 12 bolts all the way around the T-TOP holding the fiberglass hardtop on, so I didn't bother fixing it. Everything else works as it should, the windlass anchor works, salt water wash down works, fresh water wash down works, remote spot light on the T-TOP works, sink works, head ( toilet ) works, everything is listed to the best of my knowledge. Feel free to contact me to see the boat if you are local. Trailer was made for this boat 10 months ago, and comes with a 1 year warranty from T&T Boat trailers in Tampa, FL from time of purchase . I upgrade the Alum frame to a 10K pound frame, and also upgraded the tires and rims to 15" instead of 14" which is normally found on most boats this size. I also had them extend the Alum frame to the back of the boat's transom. Trailer comes with LED light's, over sized jack, front brakes, 7,000lb Torsion Axle's, no leaf springs. Paid $2,900.00 for the trailer brand new in Jan 2014 , receipts and title in hand. Thanks !
