Wood And Canvas Canoe Boats for sale

1-6 of 6

Sort By

16' WOOD/CANVAS CANOE W/ SAIL KIT.

16' WOOD/CANVAS CANOE W/ SAIL KIT.

$750

Vinton, Virginia

Year -

Make -

Model -

Category -

Length -

Posted Over 1 Month

CANOE WAS USED BY NEIGHBOR AS BOY SCOUT. "WARNER BOAT' WISCONSIN. OWNED SINCE 1972 UNDER COVER. NO ROT. CANVAS NEEDS PAINT. RECENT PHOTOS AVAIL. SAIL/MAST BRASS FITTED. CANVAS SAIL/SEVERAL PADDLES W/ BRASS TRIM. BUILT IN 1940'S

CANOE SPECIAL

CANOE SPECIAL

$1,500

West Jordan, Utah

Year -

Make -

Model -

Category -

Length -

Posted Over 1 Month

NAVARRO 16' LOON ALL WOOD INTERIOR  If Purchased New $2,600-$3,300 This package includes: 2 Wood Paddles- if purchased new (90.00 ea.) 2 Life Jackets- if purchased new (50.00 ea.) 2 Folding Wooden Seats- if purchased new (50.00 ea.) 2 Loading Brackets 1 Canvas Cover

1952   CZT Penn Yan swift wood/canvas  vintage boat

1952 CZT Penn Yan swift wood/canvas vintage boat

$3,500

Bryan, Ohio

Year 1952

Make Penn Yan

Model -

Category -

Length 12.0

Posted Over 1 Month

12 Penn Yan swift CZT double cockpit professionally restored by The Wooden Canoe Shop, Inc. This was an excellent hull with no rot nor damage whatsoever. The interior was completely stripped, and re-tacked as needed. All brightwork was stripped and varnished with Epifanes high gloss marine varnish. New #10(14oz.) canvassed was installed,filled, and painted the Penn Yan swift zig-zag design. The canvas was glued on the planing section as it was originally. The boat has a dealer installed steering wheel with cable and pulleys. The wheel has been installed, but the cable steering has not. It is intact and included. No motor nor trailer is included. Pickup only in Bryan, Ohio The boat's advertised weight is 182lbs, and is rated for a 25hp motor. I'm fairly certain that it had a 25hp Johnson "Big Twin" on it originally. I have seen a lot of swifts, and it is hard to find one as nice as this one. I can store the boat until April 1st, if the price is paid in full. The restoration has just been completed in my shop. If you would like to see the boat or talk in person, call 419.636.1689, Gil Cramer

Wood Row Boat Vintage Tender Hand made Antique unique 1930's - 1940's Old

Wood Row Boat Vintage Tender Hand made Antique unique 1930's - 1940's Old

$1,750

Fairhaven, Massachusetts

Year -

Make -

Model -

Category -

Length -

Posted Over 1 Month

Wood Row Boat Vintage Tender Hand made Antique unique 1930's - 1940's Old Very Rare Old Hand Made Wooden Boat with ribs shown and hand nails on hull lap boardsNot sure of the wood species, some look mahogany, some? about 8 ft long I don't know anything about this old boat. Besides it's old and handmade has a couple brass oar pieces on rails Boat has a hole and some dry rot in different areas rails are missing rope and have damage Signs of old canvas cover over wood lap hull visibleThis was a barn find in Cape Cod Massachusetts (((( I think the boat is from Maine Canoe Company Boat, But I'm not 100% positive ))))) It seems restorable or use for nautical decor as the workmanship is amazing detail see pictures for more details in "sold as is" it's super craftsmanship at it's finest. SHIPPING IS POSSIBLE>>> CONTACT ME FOR QUOTE --

1985 LM 32

1985 LM 32

$49,000

Bristol, Rhode Island

Year 1985

Make LM

Model 32

Category Pilothouse Boats

Length 32'

Posted Over 1 Month

1985 LM 32 This 1985 LM 32 is located in Rhode Island She is a magnificent example of a canoe stern pilothouse sailboat, which typically provides excellent sea keeping ability. She comes equipped with radar, GPS, auto helm, and has a white bimini top over the cockpit as well as a blue mooring cover. Very comfortable below she's a great example of Danish boat building. The LM in this case stands for  Lunderskov Møbelfabrik. (I know-  easy for me to say). Let's just stick with LM. Powered by a Yanmar diesel with only 261 hours on it. All LM boats came with a very complete list of standard equipment, including lifelines, pulpits, speedometer, depthsounder, boarding ladders, anchor and rode, fenders, fire extinguishers, and even dishes and cutlery. She does have a crack in the forward hatch that has been repaired so there's no leakage, but you might want to consider getting it replaced.The LM32 The 32 shares all the obvious characteristics of the LM line—particularly the distinctive canoe stern and pilothouse. In most respects, it is simply a larger version of the smaller models. The boat is 32 feet in length and has a 27-foot, 10-inch waterline; its beam is 10 feet 8 inches, and it draws 4 feet, 11 inches. The bilge keel models (called twin-keel in some brochures) draw 4 feet, 1 inch. Displacement is 12,000 pounds, with 4,400 pounds of ballast.Accommodations The LM32’s cockpit is sizable considering that canoe-stern boats usually have shortened cockpits. There are bench seats on each side of the cockpit, and a large fold-out table easily can seat six. The boat has a white canvas bimini that covers the cockpit. There are lockers under each of the bench seats—propane tanks on the port side—and a huge locker under the cockpit sole. At the top of the rudder-stock is an attachment spot for the removable tiller, which can be used if you want to sail from the cockpit rather than from the pilothouse. The wheel steering in the pilothouse has a mechanical disconnect so the tiller moves freely. At the forward end of the bench seats on each side are the halyard and reefing lines, which run inside a channel on the side of the pilothouse and terminate in cam cleats in front of stainless  winches. The mainsheet has a single cam-cleat attachment point at the back edge of the pilothouse, and the sheet hangs down into the cockpit. At the front of the cockpit, double sliding doors open up to the pilothouse. On the starboard side is the steering station with a raised captain’s seat and a second fold-up seat that slides out so two people can share the helm. A wood steering wheel is immediately ahead, and engine controls, the electrical panel, and sailing instruments are directly in front of the helmsman. The chart table is immediately ahead of the wheel. This setup is good for laying down a chart so the helmsman can see it.

1950  Herreshoff  Custom Motor Launch

1950 Herreshoff Custom Motor Launch

$30,000

New Port Richey, Florida

Year 1950

Make Herreshoff

Model Custom Motor Launch

Category -

Length -

Posted Over 1 Month

A buyer should instruct his agents or his surveyors to investigate such details as the buyer desires validated. Boats Antique and Classics 8536 PSN . Anything that could be replaced has been replaced. Over the years she evolved including a 1979-1992 restoration that replaced almost all of the mahogany and added epoxy to insure durability. This vessel is offered subject to prior sale price change or withdrawal without notice. Francis Herreshoff designed two-cabin yacht. In between there are two large hanging lockers galley u-shaped dinette and an enclosed head with mirrored vanity and shower. Built by Luders Marine Construction of Stamford CT in 1950 she was a beautiful mahogany creation. Completely fiberglassed over she has epoxy coated plywood decks under the fiberglass. This one of a kind motor launch is available for someone who understands and appreciates unique vessels. On deck we have 47’ of deck space beginning up front with a bow pulpit with tall rail anchor and windlass and ending aft with a canoe stern. Purchased by her current owner in somewhat disrepair she began a long-term restoration from 1979-1992. There’s a Dickerson wood/coal burning stove for chilly days and nights. Mahogany bulkheads and copper worm shoe are details that define her beginnings. Details include ship’s clock overhead rod racks and stained glass ports. Accommodations Forward V-Berth with Under-Berth Storage Hanging Lockers - Port and Starboard Two Companionways Enclosed Head with Shower Galley Stained Glass Opening Ports Dickerson Wood/Coal Stove U-Shaped Dinette Double Aft Berth Galley Three-Burner LPG Range with Oven Litton Microwave Oven AC/DC Refrigerator Galley Sink with H&C Water U-Shaped Dinette Mast & Rigging Aluminum Signal Mast Stainless Steel Rigging Cockpit Enclosure Deck & Hull Bow Rail Bow Pulpit Anchor Anchor Locker Electric Windlass All Original Hardware Open Cockpit Canvas Enclosure Canoe Stern Mechanical & Electrical 1985 Westerbeke W-70 FWC Diesel Engine Hurth Transmission with 2:1 Reduction Twin Racor Fuel Filters Honeywell Generator Electric Head with Macerator Water Heater with Heat Exchanger Spare Shaft and Two Spare Propellers Triple Axle Custom Trailer disclaimer the Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. the galley has mahogany cabinets sink range and refrigerator. Finished in mahogany with parquet sole there is abundant storage with everything easily accessible. A Honeywell generator provides on-board electrical power. Much of the cockpit has been enclosed features added and she now has the comforts of home.   History FREELANCE is a custom-built L. A ship’s wheel compass and engine controls are all that’s needed to operate this vessel along with a VHF radio a concession to modern times. Call now for more information on this 1950 Herreshoff Motor Launch. Built of mahogany this 47’ motor launch began life in 1950 as an open cockpit twin screw launch with two cuddy cabins. New mahogany fixed with bronze screws and protected by epoxy coating has created a 99% new vessel. 1950 Herreshoff Custom Motor Launch Location: Groveland MA US   "Motivated seller says bring me an offer!!!"    (LOCATION: Groveland MA) To call this custom Herreshoff Motor Launch rare piece of marine history would be an understatement. This is a one-off creation of marine legends designer L. Below we have double berths at the extreme ends of the vessel. Freelance is powered by a Westerbeke W70 FWC diesel engine for dependable and economical operation. In between we have lots of deck space with all original hardware an enclosed cabin and open cockpit with canvas enclosure. Francis Herreshoff and builder Luders Marine...